Thorsten Greinert, Kristina Vogel, Jan-Kristof Mühlenweg, Gabriele Sadowski, Thomas Maskow, Christoph Held “Standard Gibbs energy of metabolic reactions: VI. Glyceraldehyde 3-phosphate dehydrogenase reaction” Fluid Phase Equilibria, Volume 517, 1 August 2020 https://doi.org/10.1016/j.fluid.2020.112597
Abstract
Glycolysis is a very central metabolic pathway for many organisms because it represents a key component in their energy production. For this reason, it has always been an extensively studied pathway. The glyceraldehyde 3-phosphate dehydrogenase (GDH) reaction is an important reaction of glycolysis yielding nicotinamide adenine dinucleotide (NADH). The aim of this work is to investigate the thermodynamics of the GDH reaction and determine the standard Gibbs energy of reaction ΔRg'0 and standard enthalpy of reaction ΔRh'0. Currently, so-called ‘standard’ data exist in the literature that depend on the conditions they were measured at. In this work, ΔRg'0 and ΔRh'0 values were determined that are independent from reaction conditions by accounting for the activity coefficients of the reacting substances. Therefore, the equation of state electrolyte Perturbed-Chain Statistical Associating Fluid Theory (ePC-SAFT) was used. The required ePC-SAFT parameters were taken from literature or fitted to new experimental osmotic coefficients. A value of ΔRg'0 = 51.5 ± 0.4 kJ mol−1 was determined at 298.15 K. This value deviates by up to 10 kJ mol−1 from existing literature values, caused by activity coefficients in the reaction medium. It can be used to determine the Gibbs energy of reaction ΔRg'0, which will allow statements concerning the feasibility of the GDH reaction. Further, a method is presented to predict influences of pH, initial substrate concentration and Mg2+ concentration on the reaction equilibrium. Finally, we measured the standard reaction enthalpy for the GDH reaction ΔRh'0 by titration calorimetric measurements (ΔRh'0 = 4.6 ± 0.1 kJ mol−1). This value was within van ’t Hoff evaluated ΔRh'0 (9 ± 16 kJ mol−1) using temperature-dependent equilibrium constants from equilibrium measurements corrected by ePC-SAFT predicted activity coefficients.